📫 FedEx is currently experiencing service disruptions which may impact orders. We apologise for any inconvenience.

Extruders, HotEnds, New Products, Product Updates

Titan Aero: What do you get if you cross a Titan with a V6?

Since smashing into the world of extruders with Titan back in March 2016 the next logical step for E3D was to integrate a Hot End into it, compress it as much as possible and make an ultra-compact all-in-one extruder and hotend.
Tips & Tricks

Scaffold: More than just support? Experimenting with soluble moulds for composite parts

It’s been a while since we blogged about something that’s just pure, unabashed, experimental geekery. As proud as we are of our products and as much as we love sharing them with you, we’re also tinkerers at heart. With this in mind, this blog post is about taking one of our established products (Scaffold Soluble) and pushing it as far as we can.
News, Product Updates

A Long-Awaited BigBox Update

This blog post is a big one, going into the good, bad, and unexpected challenges of the BigBox project.
HotEnds, New Products, Nozzles, Product Updates

Nozzles and Blocks and Hobbs, oh my!

Get your digits fiddling with E3D's new hardened hobbs, plated copper heater blocks, and nozzles. Note that we said plated copper, not copper plated! 
New Products, Nozzles, Product Updates

0.15mm High-resolution nozzles: For really very extremely small prints

The 0.25mm nozzle has been available for several years now, but really it isn’t all that much smaller than a “standard” 0.4mm nozzle. So how small could we go?