Hemera HeatBreak
Hemera HeatBreak
In stock
Couldn't load pickup availability
Hemera stainless steel HeatBreak
A replacement 1.75mm stainless steel Hemera HeatBreak. Although this HeatBreak uses an M4 thread on the cold side, the hot side remains an M6 thread to maintain compatibility with the V6, Volcano and Super Volcano heater blocks.
Hemera titanium HeatBreak
Titanium Hemera HeatBreaks are the perfect upgrade for printing at higher temperatures, helping to maintain a sharply defined melt zone at higher temperatures.
Genuine E3D HeatBreaks feature a refined internal surface finish to reduce extrusion force and improve retraction reliability. Made from grade 5 titanium, these HeatBreaks are exceptionally strong and have lower thermal conductivity than stainless steel HeatBreaks, allowing you to keep the cold side of your HotEnd even colder.
The increased strength of these breaks means that they are also much less likely to crack or snap, either while hot-tightening or on the occasional collision with printed parts or printer bed.
Please note:
Thermal paste is not supplied with the HeatBreak. Spare sachets can be purchased here
E3D HeatBreaks are compatible with E3D products only, we are unable to provide support if paired with 3rd party products.
⚠️ WARNING: This product can expose you to chemicals including Mineral Oils, which is known to the State of California to cause cancer, and Lead and Nickel, which are known to the State of California to cause cancer and birth defects or other reproductive harm.